Adjustable DC power supply, 4-30V AC/DC input, 1.5-27V DC output
ACDC
$14.95 USD
Used for powering the amp and volt meters.
Input: 4-30V AC/DC
Output: 1.5-27V DC (adjustable)
With each power supply we also include:
(4) 1/4" Nylon Standoffs, 4-40 Thread
(4) 4-40 Nylon Screws
(4) 4-40 Nylon Nuts (for those who do not wish to thread and tap the back plate)
Nylon standoffs and screws are the best way to keep the leads on the bottom of the power supply circuit board from shorting out against the back plate (destroying the power supply and possibly the meter as well).
For installation and wiring instructions, see our Control Panel (Part 1) and Control Panel (Part 2) build guides.
Separate power supplies are required for the meters as the volt meter has one of the AC inputs tied to the DC ground. For more information see the 'How it works' section of our volt and amp meter wiring instructions. If replacing a meter that was damaged due to incorrect wiring, we recommend that the power supply be replaced at the same time as it may have also been damaged.
Visit the official Volt/Amp meters & power supplies product thread in our forum.
Related Items
NEMA L14-30 (125/250VAC, 30A) twist lock electrical male receptacle
$49.95 USD
Used as a power cord receptacle on a 30A control panel. Industrial grade and twist locking for safety. 4 wire. White. Included in our Standard 30A Electric Brewery Control Panel (DIY Kit).
NEMA L6-30 (250VAC, 30A) twist lock electrical female receptacle
$59.95 USD
Used as heating element receptacles on control panels. Industrial grade and twist locking for safety. 3 wire. White. Hole diameter: 2.125". Used in our control panels since summer/fall of 2023. If you require a replacement, best to measure to confirm....
NEMA L5-15 (125VAC, 15A) twist lock electrical female receptacle
$24.95 USD
Used as a 120V pump receptacle on a control panel. Industrial grade and twist locking for safety. 3 wire. White. Included in our Electric Brewery Control Panel kits.
Replacement control panel enclosure key
$12.00 USD
Our pre-assembled control panels, control panel kits, and bare enclosures all include a key to open the enclosure, but sometimes brewers lose things! This replacement key will fit any of our enclosures sold from approximately 2012-2013 onwards. Check if your enclosure lock...
