QDFEMALE
$15.95 USD
Quick disconnects are (as the name would imply) connectors that can be connected and disconnected quickly. These seal very well (no drips at all) and support liquid flow in either direction. Mates with the male end to form a locking seal. The female end comes with a spring loaded cover (that must be pulled back when connecting or disconnecting), ball bearings that lock into the male groove, and a food grade o-ring that creates the seal.
Use these together with our Stainless steel 1/2" NPT female x 1/2" barb fitting fitting to finish the ends of your hoses.
We opted to use two pieces as adding the barbed fitting makes the solid ends of the hose a bit heavier (better when sparging into the boil kettle and filling fermenters) and a bit longer (easier to grip).
304 Stainless.
Note: For quick disconnects always purchase the male and female ends from the same manufacturer to ensure proper fit. Improper fit can lead to leaks (fit too loose) or damaged o-rings / o-rings that get dislodged (fit too tight).
$49.95 USD
Used as a power cord receptacle on a 30A control panel. Industrial grade and twist locking for safety. 4 wire. White. Included in our Standard 30A Electric Brewery Control Panel (DIY Kit).
$59.95 USD
Used as heating element receptacles on control panels. Industrial grade and twist locking for safety. 3 wire. White. Hole diameter: 2.125". Used in our control panels since summer/fall of 2023. If you require a replacement, best to measure to confirm....
$24.95 USD
Used as a 120V pump receptacle on a control panel. Industrial grade and twist locking for safety. 3 wire. White. Included in our Electric Brewery Control Panel kits.
$12.00 USD
Our pre-assembled control panels, control panel kits, and bare enclosures all include a key to open the enclosure, but sometimes brewers lose things! This replacement key will fit any of our enclosures sold from approximately 2012-2013 onwards. Check if your enclosure lock...
© 2024 The Electric Brewery. All rights reserved. Powered by Shopify