2 position maintained selector switch, 1 normally open (NO) contactor, 10A/240VAC

2 position maintained selector switch, 1 normally open (NO) contactor, 10A/240VAC

Required: 6 or 8 (see below)

Buy at:

Used in:

The switch requires a 22mm mounting hole, at least one normally open (NO) contactor, and the selector position must be maintained (not spring back) when turned to either of the two positions. The contactor only needs to support the highest current device (in this case the pumps at approximately 1.4A), but most contactors will support up to 10A/240VAC.

For better than average industrial switches with tight, reliable make/break switching consider the switches we sell (we've been through many brands over the last 10+ years).

These switches are included in our control panel kits.

Purchasing through our affiliate links helps support our site at no extra cost to you. We thank you!